Get outside and enjoy your day in this water resistant windbreaker jacket!

Self neck tape. Antique brass eyelets. Antique brass 6 snap front closure. Elastic cuffs. Underarm grommets. Drawcord closure at bottom opening. Screen print friendly. Standard fit. Tear away label.

(150g), 100% nylon. 320 Denier with Interior PU waterproof coating. Nylon Outer Shell: Waterproof Coating = Level 3. Inner PU Coating: Breath-ability/Permeability = 5,000. Water Pressure Resistance = 10,000 mm. Water Resistant rating since the seams are not waterproofed, which may allow water to eventually enter through the seams or snap front closure when exposed for extended periods of time in a downpour.

Note: Use nylon or plastisol ink w/ a catalyst (hardener). Certain Poly Inks can work, ask ink supplier. Catalyst will shorten the shelf life of ink leaving left over ink unusable as it will harden. Use tight screens w/ 200+ mesh count to lay down a little less ink than would be used on tees (tees normally use a more open mesh like 110). Ink tends to sit on top of the surface of fabric as opposed to pressing into cotton type fabrics. A harder squeegee can help lay down less ink and help keep cleaner design edges. Nylon fabric tends to move more than tees on the printing pallet. Sometimes a jacket clamp is recommended when doing multi-color prints.
Curing time & temp will vary by ink types used on nylon fabrics. IMPORTANT to cure ink at the right temp w/o burning or shrinking nylon. Nylon fabrics should usually be cured at temperatures under 320. Flash at low temps to keep from burning and/or shrinking fabric.(consult ink supplier & test). Wash printed sample garments after 24+ hrs (so hardener has set) is recommended to verify proper curing and ink adhesion. ALWAYS consult ink supplier for ink, curing temps and time.